NF7-S Help with setting up singlesata hard drive

I got the NF7-S and a 160 GB WD SATA. What is the best way to connect the drive to the mobo because I have way to many options and I am not getting detection when I install XP

Make sure to remove any jumper that may be on the back of your hdd first. Connect your SATA cable to your hdd & the mobo. And when you go to install XP, be ready to press F6 right when XP setup first starts to run. I mean you almost need your finger sitting over the key to push it in time. You should see the prompt below saying something like "press F6 to install any third party drivers" right at the very first of setup. It doesn't stay there very long & lots of people never even see it the first few times they try to install XP. After setup finishes copying files you will be prompted to insert the floppy that came with your mobo to copy the SATA and/or RAID drivers if you pushed F6 in time at the first part of setup running. After that, just click next/ok till your done.

Thanks for the help. Never set up any SATA before. I already notice a little more pep in my step.

Anytime, glad to have been of some help!