- Joined
- Sep 25, 2002
- Location
- San Ramon, CA
I am having no luck modifying the Ratio (FSB:AGPCI) setting in my BIOS. After looking around the forums I have seen a few hints but nothing definitive.
If I change my Ratio from 5:2:1 to any other value (3,4,or 6:2:1) my machine does not POST. No beeps, nothing. I was guessing my PCI bus was out of spec, but I am not sure since I have nothing to really go on.
I read in the ABIT forum that choosing a ratio other than 5:2:1 will cause a change to your RAM speed ... I tried setting that to 166 and leaving it there, but no joy.
I just started the o/c on the machine and so far I found that I can get to 166 x 15x multiplier (2324MHz), or 185 x 10.5x multiplier (1942MHz).
Any help would be appreciated. Thanks!
-Todd
If I change my Ratio from 5:2:1 to any other value (3,4,or 6:2:1) my machine does not POST. No beeps, nothing. I was guessing my PCI bus was out of spec, but I am not sure since I have nothing to really go on.
I read in the ABIT forum that choosing a ratio other than 5:2:1 will cause a change to your RAM speed ... I tried setting that to 166 and leaving it there, but no joy.
I just started the o/c on the machine and so far I found that I can get to 166 x 15x multiplier (2324MHz), or 185 x 10.5x multiplier (1942MHz).
Any help would be appreciated. Thanks!
-Todd