I now have all the pieces for my 1st watercooling setup.
The waterblocks, res, pump are all 1/2" ID barbs.
My Swiftech 676 Rad is 1/2" OD quick connect.
Tubing is : Masterkleer 7/16" ID, 5/8" OD, 3/32" Wall Thickness.
My problem is, The tubing won't fit into the quick connects of the rad. Any ideas how these little buggers come off? Or a way I can make this work? Has anyone encountered this before.
Any advice apprciated.
The waterblocks, res, pump are all 1/2" ID barbs.
My Swiftech 676 Rad is 1/2" OD quick connect.
Tubing is : Masterkleer 7/16" ID, 5/8" OD, 3/32" Wall Thickness.
My problem is, The tubing won't fit into the quick connects of the rad. Any ideas how these little buggers come off? Or a way I can make this work? Has anyone encountered this before.
Any advice apprciated.