- Joined
- Aug 19, 2001
after booting the pc, the card continuously beeps. there is no drive connected to the card. during the boot process, i pressed ctrl-m to bring up the utility but it just goes on and the beep sounds after that.
i'm not really familiar with scsi and my only experience using it was thru an adaptec 29160n which booted fine even without the drive.
since this was a used card, i was thinking maybe the card is looking the previous drives connected to it?
I searched here and in google without much luck. i have downloaded the hardware guide from lsi's website still can't find any solution.
tnx
edit: i've found the audible warnings section. I still don't understand it though.
i'm not really familiar with scsi and my only experience using it was thru an adaptec 29160n which booted fine even without the drive.
since this was a used card, i was thinking maybe the card is looking the previous drives connected to it?
I searched here and in google without much luck. i have downloaded the hardware guide from lsi's website still can't find any solution.
tnx
edit: i've found the audible warnings section. I still don't understand it though.
