- Joined
- Jan 25, 2008
- Location
- Washington State
I'm back with yet another problem. I was wondering how to change the command rate for my RAM to 2T in the BIOS on a Biostar TForce 965PT. It's holding my OC back! Help!
-
Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!
Biostar 965PT Command Rate
- Thread starter avafreak182
- Start date
OP
- Joined
- Jan 25, 2008
- Location
- Washington State
- Thread Starter
- #2
Anyone?
OP
- Joined
- Jan 25, 2008
- Location
- Washington State
- Thread Starter
- #4
.
OP
- Joined
- Jan 25, 2008
- Location
- Washington State
- Thread Starter
- #5
???
OP
- Joined
- Jan 25, 2008
- Location
- Washington State
- Thread Starter
- #6
=/
- Joined
- Jun 14, 2006
ava,
I'm not familiar with the Biostar board...but not all board have all the possible settings.. are you sure your MB provides that ram setting??
I'm not familiar with the Biostar board...but not all board have all the possible settings.. are you sure your MB provides that ram setting??
OP
- Joined
- Jan 25, 2008
- Location
- Washington State
- Thread Starter
- #8
Yep
- Joined
- Feb 28, 2004
- Location
- Claymont Delaware 19703
Most 965 chipsets dont have T1 and T2.My DFI 965-S offered 1N and 2N.But would only boot at 2N.Also Not being able to set you CR to T1 isnt holding back your OC.If anything 2T is helping
you could try this though.memset 3.5 beta
http://forum.nexthardware.com/showthread.php?t=53853
you could try this though.memset 3.5 beta
http://forum.nexthardware.com/showthread.php?t=53853
Last edited:
