- Joined
- Aug 19, 2005
- Location
- Los Angeles, California
What is the proper method? What I did was apply some on the heatsink and spread it with a credit card to kind of fill in the ridges of the exposed heatpipes and smooth it out. Then I drew a vertical line on the i5 2500k without smoothing it out and pressed the heatsink into it.
However this method is not yielding me good temperatures. Maybe I put too much thermal paste?
At 1.25vcore I'm getting around 40C idle and 60C load.
However this method is not yielding me good temperatures. Maybe I put too much thermal paste?
At 1.25vcore I'm getting around 40C idle and 60C load.