CCb1E opteron VMPW

[toddm27]

check the bracket the heatsink clips to there are 4 nubs that need to be taken off for good contack without the ihs, otherwise you run the risk of burning up your chip

 

[toddm27]

see this thread about the issue
http://www.ocforums.com/showpost.php?p=4369667&postcount=1189

 

[squads]

this isnt the AMD heatpipe cooler...I'm pretty sure there is good contact actually because I was just dual priming 2.8gHz @1.48V and the load temp was 45C. If the contact was bad I'm sure that would be way higher. I just find it odd that I didnt see any improvement in temps.

I might reattach the IHS using AS5 as the interface material...that might end up helping my temps. Either that or I might sell the chip and use my 146.

 

[toddm27]

sorry, I guess it just depends on your before temps and if they aren't tha bad, don't mess with em

 

[Opteron 1100]

Got mine up to 2.9 no sweat with 1.4v , I know for sure it would do 3.0 easy

 

[WonderingSoul]

Found this:

http://wiki.extremeoverclocking.com/wiki/Opteron_Steppings

Stepping Info
CCBWE are less likely to be coldbugged.
CCBBE and CCB1E are very likely to be coldbugged.
Averaging >=2800
CCB1E 0550VPMW
CCB1E 0605XPMW
CCB1E 0608MPMW
CCB1E 0609FPMW/FPAW
CCBBE 0610DPMW (most consistent for 3GHz +)
CCBBE 0615DPMW/EPMW
CCBBE 0617FPMW
CCBWE 0602BPMW
Averaging 2600-2800
CCB1E 0606FPMW
CCB1E 0609FPBW
CCBWE 0530TPMW
CCBWE 0546XPMW/MPMW
CCBWE 0550UPMW/VPMW
Averaging <=2600
CCBWE 0534SPMW
CCBWE 0541RPMW
CCBWE 0543TPMW
CCBWE 0551UMPW/VPMW
CCBWE 0604TPMW
CCBWE 0607UPBW
CCBWE 0609FPAW