Rampage 4 extreme and Antec 1200 v3 case

[UnderToker]

Would a rampage 4 extreme board fit in an antec 1200v3 case ?

Or would I have to go for the rampage 4 formula ?
Thanks in advance

 

[Blackcoog]

It looks like it will. Sounds like this board fits which is also a extended ATX board:

http://www.evga.com/forums/tm.aspx?m=1212729&mpage=1&print=true

Might be tight. Another option you might like: http://www.newegg.com/Product/Product.aspx?Item=N82E16811119245

It isn't as flashy but it's a nice case and lists extended ATX so they better fit.

 

[soulfly1448]

I have my 1200 torn down right now for a rebuild so I measured the inside for you. From back I/O plate to the inside edge of the drive cage is just a hair over 12 inches. The usable space, measuring from the top standoff to the top of a standard size PSU is just over 13 inches. The "just over" is about an 1/8".

Tight fit but it would probably fit.

 

[Fever]

I had to cut my Obsidian 800D to fit my motherboard, not cool.. I was missing about 3/4" for it to fit.

 

[UnderToker]

hmmm im a bit too scared to buy one
i think ill go with the formula knowing it will fit

i only run 2 580s anyway

 

[Tyrkertore]

Hi there!
-Yea I know this thread is old, but if it helps:
I have a Antec 1200 with a Asus Rampage 4 Extreme: And it fits just fine!
-the board just cavers the cable management-cutouts towards the front of the cabinet.
(-also have a Corsair H100i CPU cooler -that on the other hand was a challange to fit!!)
Hope this helps!