Updated BIOS, now I get nothing on the monitor!! HELP

[kskwerl]

I was trying to install RAID 0 in windows vista 64-bit and it was telling me that Windows needs a valid system volume to install on. So I tried disconnecting all the drives but the array and that still didn't work, I tried multiples RAID drivers and still no dice, so I read somewhere justbefore someone said that you may need to update the BIOS, so I put the BIOS update on a flash drive and updated and no I can't see anything on my monitor!!!!

AM I SCREWED?

 

[kskwerl]

and theres no DVI input on the back panel of this mobo ( all my hardware is in sig) I'm gonna run to bestbuy quick to get an HDMI cable in prayers that since the backpanel has an HDMI that it might work.

 

[CompuTamer]

Hmm, try pulling the CMOS jumper out and see if you can get a beep.

 

[kskwerl]

Hmm, try pulling the CMOS jumper out and see if you can get a beep.

i get beep just no display on the monitor. I cleared the cmos and took out the battery. I took out the RAM and get 3 beeps.

 

[kskwerl]

bump

 

[Sniper.nkc]

Since this condition occurred after you flashed bios, you make need to check the following:

1. Make sure you have the correct bios for your MB
2. Make another copy of bios and flash again (old bios may be corrupted)
3. DIsconnect HDs to see if you can get into bios.