- Joined
- Mar 20, 2005
Right here we go I have been thinking which is dangerous for me as it is but I have come up with a new design for my water block
Right so I have a copper pipe that is 1 inch diameter or as near as i can find in the shop with a head to match that will hopefully screw on but I don't know till I go and look. from this I will have a small amount of pipe and then another head, or I might just weld/soldier them together.
This gives me a really small water block that should transfer the heat away really really quickly or it should in theory.
Th base of the block I am hoping will be 1/2 mm thick and into it I will encrave very fine lines to increase the surface area above the block.
The water will be thrust down onto the water blocks base and then carried out by the other pipe at the side both pipes will be welded/soldiered into place and have silicone rubber gel around them to make it water tight
The to hold it in place I will attack the copper pipe frame, I know it doesn't look pritty but iw will hold it in place with bolts that goe through to the motherboard.
Wot u thing, will it work or am I barking up the wrong well in this case design, any thoughts appreciates but I have to make one cheap for part of my £20 challenge
Right so I have a copper pipe that is 1 inch diameter or as near as i can find in the shop with a head to match that will hopefully screw on but I don't know till I go and look. from this I will have a small amount of pipe and then another head, or I might just weld/soldier them together.
This gives me a really small water block that should transfer the heat away really really quickly or it should in theory.
Th base of the block I am hoping will be 1/2 mm thick and into it I will encrave very fine lines to increase the surface area above the block.
The water will be thrust down onto the water blocks base and then carried out by the other pipe at the side both pipes will be welded/soldiered into place and have silicone rubber gel around them to make it water tight
The to hold it in place I will attack the copper pipe frame, I know it doesn't look pritty but iw will hold it in place with bolts that goe through to the motherboard.
Wot u thing, will it work or am I barking up the wrong well in this case design, any thoughts appreciates but I have to make one cheap for part of my £20 challenge