Three main points:
One:
I'm considering either the Eheim 1048 or the 1250.
The 1048 is cheaper than the 1250, for obvious reasons (lower power)
Would I notice any significant performance difference if I were to use the 1048 instead of the 1250 - since I save £20 if I order the 1048.
I'm not all that concerned over a celci or two, but if the difference is likely to be over 5c, then tell me please
Two:
This is sweet and to the point,
Is it any good?
BTW, if the link doesn't work, the Waterblock in question is the Maxxxpert Miro one.
If I buy it, It will cost me £40 (that is about $60 methinks)
If it's no good, could you point me in the direction of a better one, please. I have an AMD system, if it helps when it comes to identifying a WB. (I'm going to go copper in this system as well - I am already aware of the unhappy duo that is Copper and Aluminium)
Three:
Overall, how loud is your watercooled system when finished?
Are the pumps noisy, buzzy things, or do they just hum (or somewhere in between).
Does the change from 80 to 120 mm make that much of a difference, or will my system still sound like an aeroplane?
If any of you guys could shed some light onto any of my three main queries (concerns (headaches )) then it would be much appreciated.
Thanks!
ImG
*EDIT* added bold bits to make my post easier on the eye.
One:
I'm considering either the Eheim 1048 or the 1250.
The 1048 is cheaper than the 1250, for obvious reasons (lower power)
Would I notice any significant performance difference if I were to use the 1048 instead of the 1250 - since I save £20 if I order the 1048.
I'm not all that concerned over a celci or two, but if the difference is likely to be over 5c, then tell me please
Two:
This is sweet and to the point,
Is it any good?
BTW, if the link doesn't work, the Waterblock in question is the Maxxxpert Miro one.
If I buy it, It will cost me £40 (that is about $60 methinks)
If it's no good, could you point me in the direction of a better one, please. I have an AMD system, if it helps when it comes to identifying a WB. (I'm going to go copper in this system as well - I am already aware of the unhappy duo that is Copper and Aluminium)
Three:
Overall, how loud is your watercooled system when finished?
Are the pumps noisy, buzzy things, or do they just hum (or somewhere in between).
Does the change from 80 to 120 mm make that much of a difference, or will my system still sound like an aeroplane?
If any of you guys could shed some light onto any of my three main queries (concerns (headaches )) then it would be much appreciated.
Thanks!
ImG
*EDIT* added bold bits to make my post easier on the eye.