- Joined
- Jun 15, 2001
This helped me out a whole lot! I use tygon tubing and even those sometimes get bended and start to flatten out at places where it turns or bends, I'm sure lots of you may have that problem but all you have to do is put your extra tube clamps around it! not too tightly just enough to make the flattened part round again =)
worked for me! I can definitly feel a huge difference in waterflow just by putting my hands around the tube!
sorry if this is general knowledge and i'm an idiot, but it didn't seem too much common sense before i did it
EDIT: oh here's a pic if i'm unclear
worked for me! I can definitly feel a huge difference in waterflow just by putting my hands around the tube!
sorry if this is general knowledge and i'm an idiot, but it didn't seem too much common sense before i did it
EDIT: oh here's a pic if i'm unclear