IC7 G No Monitor Feed
Ok,
built a few rigs in the past and have never had one "not" post to bios screen. Please can someone get me out of this mess.
This is a system for a friend and im up against the wall on this one
IC7 G
430 Antec True Power
80 Gig WD
ATI 9800 256 Meg
512 Meg Corsair DDR500
2.8 P4 C
LiteOn 16x52x32x52
System will power up (little LED in corner turns red) all the fans spool up HD spools up, but moniter reports that there is no signal, i pulled the card out put it in my rig and works fin, i hooked the monitor up to my rig and that also works fine, i have double checked that all the cables are hooked up properly, and that there was power to the Vid card, im going insane here, can or will anyone lend me a hand or some ideas, im going to pull the system out and try it on card board to make sure its not some type of grounding issue with the case next.
Please someone help me
confused
Ok,
built a few rigs in the past and have never had one "not" post to bios screen. Please can someone get me out of this mess.
This is a system for a friend and im up against the wall on this one
IC7 G
430 Antec True Power
80 Gig WD
ATI 9800 256 Meg
512 Meg Corsair DDR500
2.8 P4 C
LiteOn 16x52x32x52
System will power up (little LED in corner turns red) all the fans spool up HD spools up, but moniter reports that there is no signal, i pulled the card out put it in my rig and works fin, i hooked the monitor up to my rig and that also works fine, i have double checked that all the cables are hooked up properly, and that there was power to the Vid card, im going insane here, can or will anyone lend me a hand or some ideas, im going to pull the system out and try it on card board to make sure its not some type of grounding issue with the case next.
Please someone help me
confused
Last edited: