- Joined
- Nov 20, 2003
- Location
- Sydney Australia
Ive just looked at this case and my first impression was, I WANT ONE. So im guessing im probobly going to get one next month if i have any money left over after payday, provided my parents dont give me a load of crap about it.
Im not that satisfied with the job on my Xaser III and im thinking of transferring my watercooling to it.
The parts of my watercooling loop is listed in my sig.
Im thinking of removing the top PSU bracket and turning that into an intake. Then in that area, mounting my two radiators. Ive measured it to be roughly 36cm from the back of the case to where the optical drives start and my radiators are 13cm long each. then from the radiators, going down they will go into the CPU and the GPU. Im going to be cancelling my NB block cuz it's been causing me too much greif and im probobly gonna get a Thermalright NB cooler instead. Then after the GPU block, it goes down into a T line at the bottom of the case, which stretches along the back edge of the metal piece that holds the drives in place all the way to the top with a Dangerden fill cap. Maybe lots of hot glue involved here, then after that, it goes into my pump. Then another hose goes up the opposite edge to the radiators again.
That sound good? Should i keep the radiators in paralell or should i daisy chain them?
If you have any pics of watercooled CM stackers, plz post them.
Im not that satisfied with the job on my Xaser III and im thinking of transferring my watercooling to it.
The parts of my watercooling loop is listed in my sig.
Im thinking of removing the top PSU bracket and turning that into an intake. Then in that area, mounting my two radiators. Ive measured it to be roughly 36cm from the back of the case to where the optical drives start and my radiators are 13cm long each. then from the radiators, going down they will go into the CPU and the GPU. Im going to be cancelling my NB block cuz it's been causing me too much greif and im probobly gonna get a Thermalright NB cooler instead. Then after the GPU block, it goes down into a T line at the bottom of the case, which stretches along the back edge of the metal piece that holds the drives in place all the way to the top with a Dangerden fill cap. Maybe lots of hot glue involved here, then after that, it goes into my pump. Then another hose goes up the opposite edge to the radiators again.
That sound good? Should i keep the radiators in paralell or should i daisy chain them?
If you have any pics of watercooled CM stackers, plz post them.