So I took some advice, and was able to get some 3/8" tubing over the 1/2" inlets on the MCP655 pump. I put the end of the tube in almost boiling water for 30 seconds-ish, and used needle-nose to pull it up around the edge.
Now, my questions...
1. Will this work ok?
2. Should I worry about the tubing tearing?
3. Is this way better than the 1/2" to 3/8" converter fitting way? It seems so because the fitting seemed very narrow, but just wondering.
PS:
No, I dont want to go with 1/2" tubing. It seems to big and hard to work with. I like the size of the 3/8. I dont OC anything extreme, and dont care if 1/2" gives me 1-3 drop in temps. <---- Just because someone will say go with 1/2"
Now, my questions...
1. Will this work ok?
2. Should I worry about the tubing tearing?
3. Is this way better than the 1/2" to 3/8" converter fitting way? It seems so because the fitting seemed very narrow, but just wondering.
PS:
No, I dont want to go with 1/2" tubing. It seems to big and hard to work with. I like the size of the 3/8. I dont OC anything extreme, and dont care if 1/2" gives me 1-3 drop in temps. <---- Just because someone will say go with 1/2"