Hi,
My DDR2 is rated at [email protected], but as is often the case, it runs at 800MHz by default (1.8V default). Up to now, I always used to set "DRAM Frequency" manually to 1066MHz and set the voltage to 2.24V and had no problems. However, I was wondering, if it's enough to ONLY set "DRAM Frequency" WITHOUT setting the voltage? Seeing that I set the frequency to 1066MHz, will BIOS be smart enough to increase the voltage from the default 1.8V so that the memory would run at 1066MHz without problems?
I don't want to try that since I'm not sure if it's going to lead to problems, so I'm asking here first.
The board is Rampage Formula X48.
My DDR2 is rated at [email protected], but as is often the case, it runs at 800MHz by default (1.8V default). Up to now, I always used to set "DRAM Frequency" manually to 1066MHz and set the voltage to 2.24V and had no problems. However, I was wondering, if it's enough to ONLY set "DRAM Frequency" WITHOUT setting the voltage? Seeing that I set the frequency to 1066MHz, will BIOS be smart enough to increase the voltage from the default 1.8V so that the memory would run at 1066MHz without problems?
I don't want to try that since I'm not sure if it's going to lead to problems, so I'm asking here first.
The board is Rampage Formula X48.
