SOLDER THIS, AND THAT AND THAT??? I AM...

S

spykid

Registered

​

Joined

Apr 16, 2001

• Apr 21, 2001

• #1

AHHHH! Because I am flying blind here and would like to put these bridges behind me...okay, L1 DONE...

WHAT ABOUT THE OTHERS?
SHOULD I SOLDER THEM TOO?
WHAT FOR?
SHOULD I?
THEN WHAT?
HELP MEEEEEEEEEEEE.....

I AM THE WEAKEST LINK!

goodnight.

 

F

FRANK

Guest

• Apr 21, 2001

• #2

This has been well documunted on various sites for quite some time, it sounds like a bit more research on your part is neccessary.

Here's a good place to start;

http://www6.tomshardware.com/cpu/00q3/000711/index.html

Good Luck!

 

proze

Senior Member

​

Joined

Dec 22, 2000

Location

Pretoria, RSA

• Apr 21, 2001

• #3

you shouldn't have to be soldering any other bridges if your motherboard is right. check to see that your mobo can support multiplier, vcore and fsb adjustments.

and frank is right. read up more. there's plenty of info in article form all over the show. just read, read, read.. and soon you'll be up to speed. hehehe both literally and figuratively!

good luck.

 

F

FRANK

Guest

• Apr 21, 2001

• #4

>and soon you'll be up to speed. hehehe both literally and figuratively!<

Touche'

 

OP

S

spykid

Registered

​

Joined

Apr 16, 2001

• Apr 21, 2001

• Thread Starter
• #5

Thanx for the Links and advice. My mobo does support all the changes. I was just wondering, if they were "all" connected (the bridges), would there be an advantage over leaving them "as is" even though my mobo is worthy of bios manipulation....?

 

F

FRANK

Guest

• Apr 22, 2001

• #6

Once again, do some research and make an educated decision. And once again you can begin your quest for knowlege here;

http://www6.tomshardware.com/cpu/00q3/000711/index.html