- Joined
- Feb 20, 2004
- Location
- Murfreesboro, TN
When ordering a fan to put on a heatsink (thinking Panaflo 120mm M1A on SP-97), would it be best to connect the fan to the motherboard (NF7-S v2) or to the power supply? Which of the two options will allow an RPM reading (and as a side note, what is a good fan controller?).
I'm also wanting to set up between 7 to 9 Panaflo U1A 80mm case fans in this setup. What should they connect to, as well (and how should I run them through above mentioned fan controller if you had a suggestion for one)?
Thanks,
- Dave
I'm also wanting to set up between 7 to 9 Panaflo U1A 80mm case fans in this setup. What should they connect to, as well (and how should I run them through above mentioned fan controller if you had a suggestion for one)?
Thanks,
- Dave