- Joined
- Aug 8, 2002
So I have some broken traces on a peice of hardware that I need to repair. I drew in some little "trenches" connecting the traces and then filled them in with conductive paint. Unfortunatley, I seemed to of made them to close together and caused a short. Would it be safe to remove the paint than fill in the "hole" with the silcione, and then remake the trenches?
I also was going to try bridging them with some wire, but a bunch of the traces are exposed. They are close together, so soldering would be unbelievably hard to impossible. I know I can cover these up with Acrylic Clear Nail Polish, but I just wanted to make sure I could.
If I can use the silicon, what type should I use and where may I find it?
Thanks!
I also was going to try bridging them with some wire, but a bunch of the traces are exposed. They are close together, so soldering would be unbelievably hard to impossible. I know I can cover these up with Acrylic Clear Nail Polish, but I just wanted to make sure I could.
If I can use the silicon, what type should I use and where may I find it?
Thanks!