- Joined
- Jan 25, 2003
- Location
- Newport MN
Anyone know the answer to this riddle?
-
Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!
Can I use a peltier with a Innovatek Set-2???
- Thread starter Vedder323
- Start date
- Joined
- Jan 22, 2002
- Location
- United States
Well to the best of my knowledge Innovatek doesn't make a pelt block yet. That and the tubign diameter doesn't allow for a very high flow rate stock with these kits.
I would suggest that you not try this because it seems that in the stock format these kits would be overloaded by the extra heat load of the pelt.
Perhaps with a better waterblock and radiator it might be able to handle it though. Although if you are going to go that route you may as well just get an entirely new system built specifically for using a pelt.
I would suggest that you not try this because it seems that in the stock format these kits would be overloaded by the extra heat load of the pelt.
Perhaps with a better waterblock and radiator it might be able to handle it though. Although if you are going to go that route you may as well just get an entirely new system built specifically for using a pelt.
