2500+ and A7N8x ultra question

ffactoryxx · Jan 27, 2004

im bulding a pc for some with 2500+ stock hs, A7N8X ultra and 512mb pc3200 buffalo
What should i set the mlti and fsb at?? Also what other settings in the bios do i need to change?? Im not familiar with a pci/agp divider. Ive only used my 8rda+ with locked bus

Steven4563 · Jan 27, 2004

166*11 they should be

A7N8X ultra also has a locked pci slots coz its a N-Force2

this should off went in the AMD bit

ffactoryxx · Jan 27, 2004

someone said 9x200 since i got pc3200

Steven4563 · Jan 27, 2004

yes u can do that but the stock speed is 166*11

ffactoryxx · Jan 27, 2004

could i do that right off the bat?? Or would i need a lot of testing like i did to get my 2100+ at 200fsb 2.3ghz

Steven4563 · Jan 27, 2004

it depends if your 2500+ (week 39 and above) is locked. If its locked your'll have to run it at 166*11 to get 1.8ghz but if not u can overclock to 3200+ speeds 200*11

SunRedRX7 · Jan 27, 2004

In the BIOS, set the AGP frequency to 66 to lock it there, that should also lock the PCI speed.

If you plan on overclocking it, make sure to watch your temps when you set the frequency to 200 if your using the stock heatsink. You may need a voltage bump also to be stable at XP3200 speeds, each XP2500 is different.

ffactoryxx · Jan 27, 2004

i know how to oc, just didnt know about this new board

ProBoner · Jan 27, 2004

If you aren't upgrading the HSF, then check your temps using MBM5 or SpeedFan4.09. If you're idling in the high 40's or lower, you can up the speed a bit without worrying too much.

In a locked 11x multiplier system, 182x11 will give you 2000mhz and you will most likely not need extra voltage for anything under 2100mhz (191x11).

2500+ and A7N8x ultra question

ffactoryxx

Member

Steven4563

Member

ffactoryxx

Member

Steven4563

Member

ffactoryxx

Member

Steven4563

Member

SunRedRX7

Member

ffactoryxx

Member

ProBoner

Member

Similar threads