AX-7 Heatsink + A7V8X

[Ishakir]

Hello guys,
I was wondering if anyone here has bought the A7V8X motherboard and was able to fit the AX-7 heatsink on it. I plan on buying this board sometime soon and already have this heatsink sitting over her.

Thanks a lot,
-Ish-

 

[Norrko]

I don't think there's any problem with the AX-7... A7V8X got plenty of room around the socket to fit...Just that, Big Heatsinks...
Good luck!

/Norrko

 

[cypher]

I put one on today, just a little tight with the clip toward the back where the one capictor is pretty close.

 

[Norrko]

Everything is close today... On my last MB my HS touched the prong for the Northbridge so I had to slide to the side to make it not to touch it.. But there's plenty of room on the A7V8X compared to my old Mobo...

/Norrko

 

[FleshEating Bob]

I have pretty much the same question, except with a Maze3 waterblock. Anyone know if a Maze3 will fit on an A7V8X?

 

[Norrko]

I have pretty much the same question, except with a Maze3 waterblock. Anyone know if a Maze3 will fit on an A7V8X?

Dimension of the block?

/Norrko

 

[doo888]

AX-7 works fine with the A7V8X, plenty of room available so no worries at all.

 

[FleshEating Bob]

Dimensions? 2" x 4" (approx.)

 

[JoJoMoJo]

Im using the Maze 3 from Danger Den lotssssssssss of room left over. http://www.cyberturf.com/jojomojo/IM000220.jpg

 

[rippedsocks]

my volcano 9 is very tight on the left side (with the capacitors), but it fits