- Joined
- Jul 27, 2004
- Location
- Belton, MO
I decided to upgrade from the 1.0-7676 Nvidia display driver to the 1.0-8178 driver. I had upgraded gcc so I had to recompile the kernel, so I decided that I may as well upgrade it at the same time. I switched to 2.6.15-rc6 with no problems. I then installed the new nvidia driver after patching it with the first patch in this thread.
When I started X again, my dpi resolution was messed up. I had just gotten it setup a couple hours earlier to how it should be. It changed my screen size to 1161x423 millimeters; my old setting was 726x272. My old dpi came out to be 112x112, whereas now I'm running 70x72. The fonts are now smaller than I would want them and they aren't very clear. I was able to change it to get 113x115, but that is still not were it should be.
I have messed around with the DisplaySize setting in the config file but I can't get it to where it should be.
Does anyone have any ideas to get it back to how it should be?
I'm running Slackware 10.2 and X.org 6.8.2.
I've attached my /etc/X11/xorg.conf file.
When I started X again, my dpi resolution was messed up. I had just gotten it setup a couple hours earlier to how it should be. It changed my screen size to 1161x423 millimeters; my old setting was 726x272. My old dpi came out to be 112x112, whereas now I'm running 70x72. The fonts are now smaller than I would want them and they aren't very clear. I was able to change it to get 113x115, but that is still not were it should be.
I have messed around with the DisplaySize setting in the config file but I can't get it to where it should be.
Does anyone have any ideas to get it back to how it should be?
I'm running Slackware 10.2 and X.org 6.8.2.
I've attached my /etc/X11/xorg.conf file.