• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

Please help me

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

Shiva1

New Member
Joined
Mar 13, 2006
Please help me!

Here are my specs, I just put this computer together this weekend.

Opteron 144
DFI NF4 Ultra-D
2X 512 mb OCZ Plat rev 2
Asus 6800 GT
No Audio
Cooler Master Hyper 6, with taped on fans on both sides

I got the computer to boot. I am using my old hard drive, 1 pin on the back is bent, but I bent it back into place and it seems to boot. The hard drive is out of the case, it's just sitting on my table. The first couple of times I booted it got to windows. I changed timings to 2-2-2-5 I think. And then I started raising htt. I hit 230 htt. And it was still running. Then I took the computer from a room to a different room and hooked it up to my LDC. After that I tried to boot it up. It got to windows, past the loading windows XP screen, then, a black screen appears, with a wall of text, i'm not sure what it says, it goes by too fast, then it restarts again automatically. I'm not sure what's going on. Can someone explain to me what's going on? It just reboots again and once it gets pass the Windows XP screen, the black screen with text appears for a second then it restarts again. Any help would be greatly appreciated thank you.
 
Do you have a new Windows installation or are you using one from a previous rig. If it's an old installation then you either need to to a repair install or a reformat and a fresh installation.
 
Like mention above if you had windows installed prior to switching boards you most likely will have to reinstall windows especially if your switching chipsets.
 
Back