w00t
i just got my leufkin direct die cooling block and attatched a
156W pelt to it and added a 4 pin thingy.
my PSU is a 430W true power antec.
it puts out 36A on the 5volt, 20A on the 12volt, and 28 and the 3.3
i plugged it in for about 15 seconds and snapped this pic of my
voltages to just test it.
they look fine to me, what do yall think?? i'm only powering
2 120mm deltas at 7V, 1 hdd, and the mobo + cards, so not a lot.
is my PSU gonna be good enough to handle the pelt + system?
i hope this pelt can handle 100W of heat. should it perform better
sense actual water is running on the hot side?
thanks!
i just got my leufkin direct die cooling block and attatched a
156W pelt to it and added a 4 pin thingy.
my PSU is a 430W true power antec.
it puts out 36A on the 5volt, 20A on the 12volt, and 28 and the 3.3
i plugged it in for about 15 seconds and snapped this pic of my
voltages to just test it.
they look fine to me, what do yall think?? i'm only powering
2 120mm deltas at 7V, 1 hdd, and the mobo + cards, so not a lot.
is my PSU gonna be good enough to handle the pelt + system?
i hope this pelt can handle 100W of heat. should it perform better
sense actual water is running on the hot side?
thanks!