Hi all, Im trying to determine a "safe" operating temp region for my chip. The die temperature sensor is obviously located somewhere within the chip (AMD tbred B) Im assuming not on the actual chip ceramic/organic substrate but rather In the die as the name implies. Looking at the temps im getting;
Case 25
Water Block 28
Socket (under the chip) 35
Die 49
I see that the waterblock is only 3 deg above ambient obviously my setup is fairly tame and ideally id want to have a lower block temp but still a die temp of 49 is massive in comparison. If the block temp was equal to the ambient case temps id expect that the die temp would still be 46 (this is all at 1.8v 2100B@ 2300mhz) upon casual inspection it appears the trend is 1 deg on the water block correlates to about 1 deg on the die. What is the best achievable DIE temp (NOT socket temps) people have achieved on water that is not activley cooled (eg Just a radiator, no ice or phase change setups). Interestingly after I did a volt mod to my board and jacked up the Vcore to 2.1V my die temp went up to 60deg and the difference between idle and load was 60 compared to 63. The system was still stable at 63 and the overclock achievable went up to 2450mhz.
cheers for any advice or info provided
Case 25
Water Block 28
Socket (under the chip) 35
Die 49
I see that the waterblock is only 3 deg above ambient obviously my setup is fairly tame and ideally id want to have a lower block temp but still a die temp of 49 is massive in comparison. If the block temp was equal to the ambient case temps id expect that the die temp would still be 46 (this is all at 1.8v 2100B@ 2300mhz) upon casual inspection it appears the trend is 1 deg on the water block correlates to about 1 deg on the die. What is the best achievable DIE temp (NOT socket temps) people have achieved on water that is not activley cooled (eg Just a radiator, no ice or phase change setups). Interestingly after I did a volt mod to my board and jacked up the Vcore to 2.1V my die temp went up to 60deg and the difference between idle and load was 60 compared to 63. The system was still stable at 63 and the overclock achievable went up to 2450mhz.
cheers for any advice or info provided