- Joined
- Nov 17, 2001
- Location
- Waterloo, Wisconsin, USA
Pump/Res -> Heater Core -> Block - repeat.
Maze4 AMD
Maxijet 1200
D-Tek Core + Shroud
120mm intake side panel, 120mm on Core. Both on lowest speed.
Been up for just a little over 1h:30m now and all seems well enough.
The ambient is about 24C, the case is 32C (damn), CPU at 36 full load (toast), (1337mhz, 1.7v).
I don't think I have my springs completely compressed but they sure the hell are down tight. I'm just afraid to bust my CPU (can't review a W/B without a CPU).
I'd wager the large difference between abmient and the PC is because of the low fan speeds, I'm using AS Alumina, and the CPU is a Pally, so they run a bit hot anyway. Also using the socket thermistor here, as it's all I've got.
Case temp does seem a bit high though.. Even for the low fan setting. Anyone think that has anything to do with the core being in the case ? (my previous setups have been external).
Maze4 AMD
Maxijet 1200
D-Tek Core + Shroud
120mm intake side panel, 120mm on Core. Both on lowest speed.
Been up for just a little over 1h:30m now and all seems well enough.
The ambient is about 24C, the case is 32C (damn), CPU at 36 full load (toast), (1337mhz, 1.7v).
I don't think I have my springs completely compressed but they sure the hell are down tight. I'm just afraid to bust my CPU (can't review a W/B without a CPU).
I'd wager the large difference between abmient and the PC is because of the low fan speeds, I'm using AS Alumina, and the CPU is a Pally, so they run a bit hot anyway. Also using the socket thermistor here, as it's all I've got.
Case temp does seem a bit high though.. Even for the low fan setting. Anyone think that has anything to do with the core being in the case ? (my previous setups have been external).