2 80mm-rad
2 80mm-back of case (1 in 1 out)
2 80mm-psu (1 in 1 out)
1 80mm-side blowhole (in)
1 80mm-hdd "cage" (in;3 hdd's)
1 crystal orb-nb (dont work for monkey B@**$ i get better temps with nothing at all on my nb)
1 vantec icberg-video
total=10
would be more but i dont think i have enough places to put um
P.S. Masterchief: I think that your sig may be in violation of the sig rules. Not trying to be a stickler, but I though I would let you know before a mod notices.
2 at low front in : lian li's standard
1 at back : lian li's standard
1 at top : lian li standard
1 for psu : psu standard
1 for hs :sf2 with temp censor
1 for duct mod direct to hs's fan : sf2 with manual adjustment
1 in internal case blow up through the gap between VGA card and hard drive : Vantec stealth (i'm hoping that will push my front 2 cold air up to NB and SB quicker)
So here's a question related to this, what about orientation? Do most of you have them placed bottom up, so that you're pulling air in at the base and exhausting at top/back? I'm curious as I'm getting ready to add a few more fans to to my setup as the measly 4 I have just don't cut it. Unfortunately my computer room is quite warm during the summer and my system is running at 36°C/70°C under load consistently with an open case and a house fan on it at the moment. It locks up if I don't do this.
What concerns me is that my system sits on the floor, and gets quite dusty. So pulling air into the system with bottom mounted fans would probably just worsen the condition I'm thinking. Filtering is an option, but I'm undecided on what material works best without affecting airflow.
4 front intake
2 back exhaust
1 blowhole
2 side (120mm) intake
1 tornado 92mm cpu
1 80mm fan hovering over my memory
1 80mm fan blowing towards my fan controller
2 fans on my power supply
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.