ARGH!!! Did I kill it?

I was installing some 1/2" H20 stuff the past few days,
1/2" fittings on pump, CPU block, installed a NB cooler,
new hoses... yada....

I was reinstalling my vid card (GF4 Ti4400)
& #3 memory clip was open,

I gave it a pretty good push & finally stopped & looked what what was going on.

I "closed" the clip inspected the vid card.
No visual damage.
it was hitting squarely on the side.

So no tracer damage I can see.

I went out to the garage to pull out the trusty GF2
& dropped it on the way into the house.

Needless to say, I still have no video signal.

I'm really bummin hard now.
Think I killed the mobo? or the vid card? card slot?


Sorry, it's an 8RDA+ ver2

sounds like the mobo, as you may have already known

prolly the mobo if you tried two vidcards. I'd suggest resetting the cmos and attempting again...

I pulled the mobo & tried the same 2 vid cards on a different board, and they worked just fine.


Time for that NF-7s.