Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!
to the Forums
oh the irony... #Laughs#
excuse my bizzare opening comment, take a look at this post and you`ll see why im tickled by the situation.
http://www.overclockers.com/forums/showthread.php?t=641495
just two posts under your thread now
Lazy BobbyBubblehead? +_+
Why dont u build ur own computer than a overpriced alienware? ( they were some time ago i dunno if its still the case...)
As for me it's always funnier to build something on your own then buying something already made. -- this is my opinions
I was looking at there site and wonder can you order without watercooling?
just my feelings on it
as for GPU blocks thats something we have to address within the one week before purchase zone, because we need to make sure what revision the card is and therefor which block will fit.
I envisage to buy the EVGAGeforce GTX 480 Hydro Copper, so I don't need a vga block...
I think when I see the picture of the kit, the question is : is it compatible with an Alienware Aurora Case ?
I envisage to buy the EVGAGeforce GTX 480 Hydro Copper, so I don't need a vga block...
I think when I see the picture of the kit, the question is : is it compatible with an Alienware Aurora Case ?
if it was my purchase, I would obtain the following:-
2of 3x120 rads
D5 vario (similar to the swiftech pump)
then take a look at the CPU block http://www.overclockers.com/forums/showthread.php?t=641191 see what you can pick some up for.
the swiftech northbridge and res would be fine.
then whatever full cover GPU block suites best at the time.
some G1/4 barbs where needed e.g. the rads would need four for a start.
and some 3/8 tubing roughly measured and add another two or three foot for waste through cutting and mistakes.
throw in some plain distilled and a silver killcoil or petras pt nuke.
oh and equip the rads with some low to med speed yate loon fans.
I would be confident I could get some clocking and a drop in noise with such parts