- Joined
- Jan 18, 2003
Ok I have read thru the big thread about this board and havn't found what I'am looking for. I dont really like soldering on motherboard's and really like using smd grabber's.
According to this you can change the resistor from a 2.1k ohm to 150 ohm and get around 3.04 vddim.
I would like to know if you can use the pencil trick for this to lower the resistance and get maybe 2.85 vddim or 2.9?
For the vcore I have found the you can use different ohm resistors and get different level's of a vcore setting by using this guide
Also I have found that you can get a solid 1.55 vcore using this But I want to be able to have an adjustable vcore where maybe 1.45=1.6.
Any help would be great.
Jonspd
MOD's
1.Vcore
RHCF mod found here
OCWorkBench mod found here
techPowerUp mod found here
ochungry 1.5 vcore mod and 1.375-1.45 normal vcore in post 28
2.Vddim
RHCF vddim mod found here (same page as vcore mod just further down the post)
OCWorkBench mod found here
techPowerUp mod found here
ochungry easy mod without soldering found in post 141
3.Vdrop provided by persivore @ xs here
4.Vldt_Vdd_Vagp provided by persivore @ xs here
5.Vpci-e provided by persivore @ xs here
6.Vtt and Vsb provided by persivore @ xs here
7.Voltage Read Point's.
Vdd and Vldt here
Vagp here
Vpci-e and vtt here
8.Vddim & Vldt Read Via MBM5.
Thanks to ochungry for moding the winbond chip here
BIOS
04XX found here
OCW found here
References
DataSheet's provided by persivore @ xs
Vcore
LM324 (used for Vdimm, Vtt, Vsb, Vnb, Vldt, Vcca, Vagp)
Others
Understanding Resistors here
Resistors calculator. here
Any other link's for info about helping mod this board plz post them or P.M. me.
Jonspd
Last edited: