I know a lot of poeple are folding with the ECS K7S5A well i did a vmod on my ak12a and found out they use the same voltage regulator(KA7500A). I posted the mod in the thread -= Get Your Volt Mods Here! =-
Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!
Thanks res! Since I have both of those boards, I'll have to take a look. But, what good did the vmod do? You can't increase the fsb or the multiplier.res0r9lm said:I know a lot of poeple are folding with the ECS K7S5A well i did a vmod on my ak12a and found out they use the same voltage regulator(KA7500A). I posted the mod in the thread -= Get Your Volt Mods Here! =-
NedClocker said:
Thanks res! Since I have both of those boards, I'll have to take a look. But, what good did the vmod do? You can't increase the fsb or the multiplier.
I am using cpufsb with it I can raise my fsb up to 166. right now I am running 150fsb I need to get a small resistor to increase vcore more or probly get a potenimeter so I will be able to adjust with just a twist of a knob. my next step up is 10.5*155 that should get me 1627 if the ram can handle it.NedClocker said:
Thanks res! Since I have both of those boards, I'll have to take a look. But, what good did the vmod do? You can't increase the fsb or the multiplier.
ok, thanks, funnyperson. I've got that on 2 of my K7S5A machines. Need to take time to put it on the 3 new ones.funnyperson1 said:
there is a special bios which allows the ECS K7s5a to be oced via fsb...
NedClocker said:
ok, thanks, funnyperson. I've got that on 2 of my K7S5A machines. Need to take time to put it on the 3 new ones.
I was thinking of the AK12a that res mentioned.
I have one of those, too. On that board, hopping up the voltage is not the problem; I can do that on the bridges really easily.
But, on that board, there is no way to increase the fsb or the multiplier. I hadn't thought about using cpufsb.
Oh, ok, I didn't think about that.res0r9lm said:
you won't be able to get past 1.85 using bridges.
It always seemes to run a little higher than my epox.res0r9lm said:ned how accurate is the ak12a on temps. @1627 raised my vcore up to 1.92 w/ hsf swifty mc 462 and now I'm getting 44c while folding and when I had it in my ak31 it was @1654 w/ vcore of 1.95 and only 42c w/ swifty mcxc 370. atleast I'm stable now.
NedClocker said:
It always seemes to run a little higher than my epox.
The k7s5a definitely reads higher.
probably so. ram should be handling it. is it pc133?res0r9lm said:
thats what I thought. still getting unstablity after a few hours I know it's not the cpu. it's eithier chipset or ram can't handle 155 fsb. I'm thinking it's the chipset.
NedClocker said:
probably so. ram should be handling it. is it pc133?
Me either. It's probably made by some other company and then xerox sticks it's name on it.res0r9lm said:
yea it's xerox pc133 just never heard of anybody using that brand