Connecting Radiators (MM Ascension Case)

[Radeon28]

Hey all,

I've finally decided to move my computer into an Ascension Case by Mountain Mods and I have run into my first roadblock.

I had intended into bridge the radiators by using 90degree barb fittings (I know they are bad, but they were lying around not being used). Unfortunately, there isn't enough space to point two 90 degree fittings at each other and connect them, so I'm back to the drawing board.

I would prefer to not use two straight barbs and make a "u turn" with the tubing; I think that will look terrible. Any thoughts on how to bridge them, or know of a barb fitting that would work well in this situation??

 

[Supertrucker]

http://www.frozencpu.com/products/1...tte_Black_Rotary_90_G14_Adapter_BP-MB90R.html x2

Plus a http://www.frozencpu.com/products/9..._1_Slot_Spacing_CNT-VDA2_.html?tl=g30c101s873

Looks like it would work

Edit: for added bling you could use a bitspower crystal link pipe, would just need to cut it to length cleanly.

 

[GTXJackBauer]

http://www.frozencpu.com/products/1...tte_Black_Rotary_90_G14_Adapter_BP-MB90R.html x2

Plus a http://www.frozencpu.com/products/9..._1_Slot_Spacing_CNT-VDA2_.html?tl=g30c101s873

Looks like it would work

Edit: for added bling you could use a bitspower crystal link pipe, would just need to cut it to length cleanly.

+1

Also if its possible by doing some measurements you might be able to use this with some short extenders on the end.

 

[m0r7if3r]

If you have enough play in the spacing you could use one of these http://www.performance-pcs.com/cata...fo&cPath=59_346_393_611_624&products_id=29048

EDIT: Naturally you'd need a male-to-male fitting as well