H80i spacing behind motherboard required? No heatsink cut out in my case

[pmap93]

Hello

I plan to buy an H80i and I wanted to know if it will fit my case?

I have cosmos S and there is no cut out present on the motherboard mount.

So the space I have between the motherboard and the bottom of the plate is very small compared to this generation's cases

I would like to know what are the spacing requirements for the rear bracket of the H80i?

 

[EarthDog]

You already asked this...http://www.overclockers.com/forums/showthread.php?t=748381

The Intel H80i backplate is super thin... check it out at newegg.com

 

[Johan45]

I highly doubt it'll be much if any bigger than the HS mount you're currently using. You should be just fine.

 

[pmap93]

You already asked this...http://www.overclockers.com/forums/showthread.php?t=748381

The Intel H80i backplate is super thin... check it out at newegg.com

I'm sorry must be my friend who asked then, so it should be fine thanks

I highly doubt it'll be much if any bigger than the HS mount you're currently using. You should be just fine.

I'm using i7 stock cooler sir (1st gen)

 

[EarthDog]

You have two people using the same account? It would be best, to prevent things like this in the future, to have your friend create his/her own account.

 

[pmap93]

Happy to report it works perfectly, with standard standoffs, and has about 1 or 2mm left till the bolt and bracket touches the rear chassis panel