- Joined
- Apr 5, 2010
- Location
- New Hampshire, USA
- Thread Starter
- #21
The bottom support beams were made from .5x.1-inch aluminum flat bar. I wasn't keen on having to hand drill and tap them, so instead, I routed grooves to accept nuts.
I like this fastening method because its wicked strong and offers just enough "play" for easy assembly.
The frame is bolted to the front inner sheet.
And then the entire subassembly is bolted to the front frame.
I like this fastening method because its wicked strong and offers just enough "play" for easy assembly.
The frame is bolted to the front inner sheet.
And then the entire subassembly is bolted to the front frame.