the wire unlocking trick, WHERE??

[JJ86]

are the pins in that picture the same 2 you connect on the thoroughbread core? pictured is the Barton conection

also any suggestions on a good NForce2 Mobo or is:
- Abit NF7-S v2.0 nForce2 MOBO for £75?
best for the money?

JJ

 

[Gnufsh]

AFAIK, they haven't changed the pinout in a long time.

 

[Xstatic]

Yes the Abit NF7-s rev 2.0 is the best OC'n board out right now.. I dont know what that would translate into american dollars but about 105 was the lowest price i seen last week. So if its anywhere close to that then its a good buy. But it dont matter what you pay for it it is still the best board.

 

[JJ86]

well i was going to buy a DFI Lanparty for £82 so if the Abit is best oc board then for £75 it will be my best option then

what you mean by AFAIK gnufsh?

JJ

 

[ColtIce]

As Far As I Know=AFAIK

 

[JJ86]

ah ty

which of these 2 is the better?
- Corsair 256MB DDR XMS3200C2PT Platinum CAS2 (MY-004-CS)
- Corsair 256MB DDR XMS3200LLPT Low Latency Platinum CAS2 (MY-013-CS)

JJ

 

[skidooosl]

the LL is the best... and i would get a new mobo forsure, that chip you have should run 2.3 ghz easy maybe even more. just make sure you spend about $30 and get some good cooling for it.

 

[JJ86]

i posted the Abit mobo and people said it best for money but looking around i found this leadtek board

*edit* forgot to mention it cost £100

http://www.leadtek.nl/nts/uk/products/mb/content.php?subject=nForce2 Ultra400 Deluxe Limited

it already has ocing options such as 100-300Mhz fsb frequency and up to 24x multiplier take a look on that website and tell me what you think please, i may consider getting it for the OC option

JJ