You would be better off using thermal adhesive. It cost more, around 15 bucks but it will work better. 2CoolTek sells both, but I highly recommend that you go with Artic Silver thermal adhesive.
i think pcnut has it for 8 or 9 bucks you can also use regular epoxy and radioshack thermal paste it would be better than frag tape. all you do is get some 5 minute epoxy and put a little on each corner of the chip and then smear some thermal paste in the middle and put your sink on and then put a little weight on it for about 30 minutes or so. its much cheaper and works very well
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.