- Joined
- May 7, 2011
- Location
- Cook->Kent
I'm curious to know if someone's already done this. In an effort to continually cut down clutter and cabling, I'm looking to move power connections from my mcx35x2 to directly on the aquaero.
Looking at the test results of the pump, at full tilt it drew ~2.23A at 26W. There's enough overhead on each channel that it could support it, in particular since these pumps wouldn't be running full speed all the time.
This doesn't apply to users of the 5 as its 1.65A and 19.8W limit rule this right out.
So, I'm curious if anyone has rewired these to run off the aquaero directly. Using two channels of course.
Looking at the test results of the pump, at full tilt it drew ~2.23A at 26W. There's enough overhead on each channel that it could support it, in particular since these pumps wouldn't be running full speed all the time.
This doesn't apply to users of the 5 as its 1.65A and 19.8W limit rule this right out.
So, I'm curious if anyone has rewired these to run off the aquaero directly. Using two channels of course.