- Joined
- Aug 27, 2002
- Location
- The OCFORUMS
Ok, this has been bothering me for a while, but i cant fit my watercooler inside my case. I screwed the res to the top, and rubber banded the ras, ans the pump has suctions, and it was fine upside down, but, realy, its butt ugly. Tubes going everywhere, and case stuck open.
I have a midtower with 4 5 1/2 bays and no 3 1/2, as i took em out. I have very little room without the watercoolr in the picture, becuase its a 4 bay case that is the size of most 3's. With rad inside the pump had no place, and with pump in no for rad. Not to mention that the res doesnt fit. I have a cube rad thats about 5/5/5, and a via aqua 1300, and a res almost exactly same size as rad. No room, any ideas? Any cheap BIG cases that look decent?
I have a midtower with 4 5 1/2 bays and no 3 1/2, as i took em out. I have very little room without the watercoolr in the picture, becuase its a 4 bay case that is the size of most 3's. With rad inside the pump had no place, and with pump in no for rad. Not to mention that the res doesnt fit. I have a cube rad thats about 5/5/5, and a via aqua 1300, and a res almost exactly same size as rad. No room, any ideas? Any cheap BIG cases that look decent?