I just got my Via EPIA 800Mhz MiniITX barebones Motherboard, 256mb of PC133 SDRAM, and a case in the mail. Despite how stupid the title of this post sounds I do know how to build a computer.
My question is, what burnin process is a good way to test the unit?
I bought all my parts from directron and I got the RAM tested.
This computer is going to be sitting on my floor and will act as the gateway between the internet (cable broadband) and my LAN, I will be running OpenBSD on it. I could load Win98 and run Prime95 and Memtest86. I've never done a "BurnIn" process before? Normally I just leave it on for 24 hours, no stress tests or anything.
Via EPIA 800Mhz Barebones
Directron 256mb of PC133 SDRAM (tested)
Directron V21 Case
Tia,
-TheComputerGuy23
My question is, what burnin process is a good way to test the unit?
I bought all my parts from directron and I got the RAM tested.
This computer is going to be sitting on my floor and will act as the gateway between the internet (cable broadband) and my LAN, I will be running OpenBSD on it. I could load Win98 and run Prime95 and Memtest86. I've never done a "BurnIn" process before? Normally I just leave it on for 24 hours, no stress tests or anything.
Via EPIA 800Mhz Barebones
Directron 256mb of PC133 SDRAM (tested)
Directron V21 Case
Tia,
-TheComputerGuy23