- Joined
- Jan 5, 2001
Anyway I got the grabbers from www.mouser.com, a resistor from radio hack, and some wire. Got the voltage to 1.85 and began the quest for the holy grail heheh
3 hours later, several reboots, and 2 removals of the cmos battery, I managed to get this beast stable at 212 fsb, 6-4-4-2.5, and 10.5x I know if I bump the voltage I could proably get 220 but what the hades, it still is a decent overclock
Temps where all over the place, even with a vantec iceberg on the northbridge, and a generic heatsink/fan on the south. Never did like seeing my cpu near 39C esp with water cooling so I just got crazy and stuck a 80mm fan over the mos chips. HOLY COW temps on both board and cpu dropped by about 10C!
Now everything is cranking along, cpu is at 33C under load, have not seen any more odd glitches. Can run everything from prime95 to futuremark stable. Dont care about the later though, i have ti4200 which as we all know just chokes on that
3 hours later, several reboots, and 2 removals of the cmos battery, I managed to get this beast stable at 212 fsb, 6-4-4-2.5, and 10.5x I know if I bump the voltage I could proably get 220 but what the hades, it still is a decent overclock
Temps where all over the place, even with a vantec iceberg on the northbridge, and a generic heatsink/fan on the south. Never did like seeing my cpu near 39C esp with water cooling so I just got crazy and stuck a 80mm fan over the mos chips. HOLY COW temps on both board and cpu dropped by about 10C!
Now everything is cranking along, cpu is at 33C under load, have not seen any more odd glitches. Can run everything from prime95 to futuremark stable. Dont care about the later though, i have ti4200 which as we all know just chokes on that